Free USA Shipping and Financing Options Available with Affirm!

Currie - RockJock 60 VXR Front Axle

Currie - RockJock 60 VXR Front Axle
$6,674.95
as low as $587/mo with
LEARN MORE
JK/JKU 2007-2017
fits
doesn't fit
your jeep

Install Difficulty

install difficulty:

Need Install Help?

find an expert

Rating

0 reviews Write a Review
In Stock

Orders Placed Before

3PM CST

ship same day

SKU:
CURRIE-JK-RCKJCK60VXR-FRNT
Fits:
JK/JKU 2007-2017
Install Difficulty:
9

Jeep People Experiences

  • Fits 2007 to 2016 JK Wrangler, Rubicon and Unlimited
  • 2 and 4-door models
  • 5 lug hubs with 1/2" studs
  • Direct bolt in
  • Highest ground clearance on the market
  • AR400 heat treated bottom skid plate
  • 3.5" .375 wall DOM steel tubes
  • 1 ton inner knuckles
  • 1350 yoke
  • Heavy duty brackets
  • 4340 35 spline shafts
 

The RockJock® 60 VXR high pinion frontend assembly for the 2007 and up Jeep JK includes the complete housing featuring the 65-45-12 ductile iron housing center (highest ground clearance 60 on the market), AR400 heat treated bottom skid plate allowing the axle to slide over rocks easily, 3 1/2" x .375" wall d.o.m. steel tubes, 1 ton inner knuckles, 5/16" thick heavy steel diff cover, 1350 yoke and all new heavy duty Currie Jeep JK suspension brackets mounted. Upper control arm brackets are equipped with Johnny Joint® rod ends for maximum articulation and unit is hydralic ram-assist ready with all ram brackets mounted/included! Axle shafts are the Currie performance 4340 35 spline inner and outer with Spicer 1480 u-joints. Outer assemblies include 1 ton outer knuckles featuring Currie "high steer" steering arm and ball joints installed, Currie exclusive 1 ton unit bearings with 5 on 5 1/2" wheel bolt pattern, 1/2" wheel studs, and JK tone rings allowing for ABS and ESP retention, 13" vented rotors (over 1" greater diameter than stock for increased braking), zinc plated caliper brackets that allow the use of the stock JK front calipers, premium manual locking hubs, and our heavy duty 1 3/8" o.d. 4130 chrome moly tie rod with tie rod ends. All you need to complete this unit are a high pinion Dana 60 ring and pinion gear set, Dana 60 35 spline carrier of your choice, a center section bearing & set up kit and labor to set it up! NOTES: This unit is set up for hydraulic ram assist steering only, it will not allow for the use of conventional steering stabilizer shocks. This unit is 68.75" wide. This unit requires the use of 17" wheels. 2012 and newer vehicles will need a computer programmer, such as the AEV ProCal Module to reset the gear ratio and tire height in the vehicle's computer. Carriers must be turned down to 8.300" o.d.

$6,674.95
as low as $587/mo with
LEARN MORE
JK/JKU 2007-2017
fits
doesn't fit
your jeep

Install Difficulty

install difficulty:

Need Install Help?

find an expert
In Stock

Orders Placed Before

3PM CST

ship same day

Rating

0 reviews Write a Review